Skip navigation

Tag Archives: 360

Ok, so I began this little “how to” in this post way back in March, and I’ve finally gotten around to buying the parts (i.e. had time) and putting it together.


DISCLAIMER: You undertake this project entirely at your own risk. By attempting this you understand that I cannot be held liable for any damage you cause to your own equipment.

That being said: seriously, audio signals are of negligible voltage. You can cause a short circuit… and nothing will happen. There’s no way you’re going to cause a fire or anything.


You can click on the pictures on this post to get the full size image. Incidentally, while I’m at it I might as well license them to you under the GPL as Attribution Non-commercial.


02082009128

So, as a recap, the components I have bought: x2 3.5mm Male Mono jacks, and x1 2.5mm Female Stereo jack.

02082009130 02082009132

(Photos showing the inner connections of each jack.)

02082009134 (2.5mm Connected to the headset.)

So: I’m using a couple of pieces of cable I had lying about, single core in two wires, core is probably about 1mm diameter. You don’t want anything more than that or wiring the ends into the jack becomes particularly fiddly.

02082009142

Wiring the mono jacks: the outer cable was marked with a white strip, and this was how I kept track of which wire was neutral.

02082009147 02082009144

02082009148 02082009151

I put a dab of solder on each connection to hold it in place and make a good connection.

At this point, don’t forget to put the outer plastic of the female jack onto the wire! It’s going to be frustrating if you have to unwire the jack afterwards to put the plastic on and start again!

02082009155 (Yes, I know it seems obvious, but… well.)

Test the headphone socket first, see if you can get anything playing through the 360 headset so you can see that you’ve wired the audio jack correctly. I would expect (if you have the same design of connector as me) that the silvery inner connection is the speaker wire connection, rather than the brass-coloured one.

02082009152

Make sure the audio is actually turned up on the headset if you’re testing it this way. Same for the mic, when you do  that. Turn it on.

02082009156 02082009157

As above, I cropped the wires to the correct length. The first photo makes them look cropped shorter than they actually are, so careful here. You want enough left to go through the holes, but not too much, or it just gets in the way.

02082009161 02082009163

A couple of dabs of solder later, and there you have it! Note that you may want to mark which jack is the mic and which is the speaker, avoiding confusion later.

02082009164


Ta da! If you do attempt this, let me know! It’d be nice to see if I can actually help anyone out here.

Next up: an overview of the equipment I use to film a “Let’s Play”. Adios.